How To Use; Using As An Upright; Electrical Cord; Control Panel - Hoover Z 700 Manual De Uso

A
B
06
Using the Z™ cleaner as an upright
DO NOT USE CLEANER OUTDOORS OR ON DAMP OR WET
SURFACES.

Electrical cord

Open the tool/cord storage compartment (A), located on the side
4
of the cleaner and remove the cord. The top cord hook swivels for
quick cord release.
ON/OFF and control panel
The DigiTouch™ control panel (B) is located at the handle base.
5
Open tool/cord storage compartment to remove cord and plug
cord into electrical outlet. Close storage door.
To turn cleaner ON, press
To turn cleaner OFF, press
The control panel allows you to choose a cleaning mode for carpet
height or hard surface floors.
For best cleaning results, select the LOW setting. If the cleaner is difficult
to push, select a higher setting.
Select the type of carpet to be cleaned:
HIGH for deep pile carpet,
MED for medium pile,
LOW for low pile, level loop, kitchen type, and other similar types,
HARD SURFACE for bare floors. The agitator is OFF; the nozzle is set at
LOW.
GENTLE BRUSH where gentler cleaning is needed. GENTLE BRUSH
can be used with any carpet height setting. With the HARD SURFACE
setting, it provides slow, gentle sweeping action on hard surface flooring.
Turn GENTLE BRUSH off by pressing again.
Automatic agitator shutoff
The agitator will turn off when the handle is in the upright, storage posi-
tion in either the upright cleaner or canister cleaner (folded) positions.
once.
again.