Hoover Z 700 Manual De Uso página 15

4. Inspect belt to ensure that it is in good condition. If belt is cracked,
gouged or broken, replace it (see following section).
5. Insert brush roll through belt and position belt over gear teeth (D)
33
on brush roll.
6. With curved ends down, slide end plates (C) of brush roll into slots
34
(E) on tool.
7. Replace belt guard (B) making sure not to pinch brush bristles in
35
guard. Turn agitator, to make sure it rotates freely.
Replace and tighten screws.
8. To replace bottom plate (A), insert the four tabs on edge of bottom
36
plate into slots on front of tool.
Pivot bottom plate down and snap closed.
D
C
E
B
A
(Cont'd)
15