Canon ELPH LT Manual De Instrucciones página 3

This device complies with Part 15 of the FCC Rjles. Operation
is subiect to the following two conditions: (1) This device may
not cause harmful Interference, and (2) this device must
accept any Interference received, including interference that
may cause undesired operation.
□o not make any changes or modifications to the equipment
unless otherwise specified in the instructions. If such changes
cr modifications should be made, you could be required to
stop operation of the equipment.
This equipment has been tested and found to comply with the
limits fora class B digital device, pursuant to part IS of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful Interference In a residential
Installation. This equipment generates, uses and can radiate
radio frequency energy and. If not Installed and used In
accordance with the instructions, may cause harmful
Interference to radio communications.
However, there Is no guarantee that Interference will not occur
In a particular installation. If this equipment does cause
harmful Interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radioH'V technician for
help.
This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus as set out in the
Interference-causing equipment standard entitled "Digital
Apparatus', ICES-003 of the Industry Canada.
Cet appareil numbrlque respecte les llmites de bruits
radloelectnques appllcables aux appareils numeriques de
Classe B prescriles dans la norme sur le matbrlel brouilleur:
"Appareils Numeriques", NMB-003 edictee par I'lndustrie
Canada.
The C€ Mark Is a Directive conformity mark of the
European Community (EC)
113