Craftmade Levy LVY24 Guia De Instalacion página 10

10. Automated Learning Process./Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
Remove battery cover on backside of remote control
transmitter by loosening screw on battery cover. Then
use tab to open battery compartment. Install one 3-volt
battery, size CR2032 (included).
WARNING: Battery is to be inserted with the correct
polarity.
Restore electrical power. Within 60 seconds of restoring
the power, press and hold the fan POWER button (
remote control for 5 seconds (or until fan blades begin to
turn). Test light and fan functions to confirm the learning
process is complete--see Section 13.
Re-attach battery cover and re-tighten screw.
IMPORTANT: Store the remote control away from excess
heat or humidity. To prevent damage to remote control,
remove the battery if remote control will not be used for
long periods.
NOTE: Remove battery with low or no charge and dispose
of properly.
CAUTION: "DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK. " - When disposing of
household alkaline batteries, it is best to check with your
local and state recycling or household hazardous waste
coordinators concerning the specifics of the program in
your area. You may also locate a recycling center by calling
800-8-BATTERY or 1-877-2-RECYCLE or visit
www.epa.gov/epawaste/index.htm or www.earth911.org
for more information.
WARNING: Choking/Ingestion Hazard - Small parts.
Keep battery away from children.
WARNING: Battery is NOT rechargeable.
Non-rechargeable batteries are not to be recharged.
11. Remote Control Operation.
button - Use to turn fan ON/OFF
button - Use to control fan direction
button - Use to decrease fan speed. Blue LED lights will
show the current speed.
button - Use to increase fan speed. Blue LED lights will
show the current speed.
button - Use to turn light ON/OFF (if applicable). Press
and hold down to use dimmer function.
button - Use to change the LED color
Option 1: Warm White
Option 2: Bright White
Option 3: Daylight
battery cover
) on
page 10
CR2032
3V
battery
REMOTE CONTROL
TRANSMITTER
(back side)
REMOTE CONTROL
TRANSMITTER
(front)
remote control