Craftmade Levy LVY24 Guia De Instalacion página 7

5. Fan Assembly. (cont.)
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [Refer to
diagram 5.]
Thread downrod into the yoke on motor assembly
until hole for pin in downrod aligns with hole in
yoke--make sure wires do not get twisted. Re-insert pin
that was previously removed. Securely tighten pin
and set screws at top of motor assembly yoke using
small Allen wrench [Refer to diagram 5.]
Slide yoke cover, canopy cover and canopy over
downrod. [Refer to diagram 5.] (NOTE: Canopy cover
must be turned with smooth side toward the motor
assembly.)
Thread safety cable and wires through hanging ball;
then slide hanging ball over downrod--the top of the
downrod should be noted as having a set screw hole;
use this hole when setting the set screw. Insert stop
pin into top of downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely. [Refer to
diagram 6.] Lower yoke cover to motor assembly.
WARNING: Failure to tighten set screw on
hanging ball completely could result in the fan
becoming loose and possibly falling.
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to
hang your fan. Grab the fan firmly with two hands.
Slide downrod through opening in hanging bracket
and let hanging ball rest on the hanging bracket.
Turn the hanging ball slot until it lines up with the
hanging bracket tab. [Refer to diagram 7.]
WARNING: Failure to align slot in hanging ball
with tab in hanging bracket may result in serious
injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure safety cable. It will
be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) with the
safety cable loop. If necessary, adjust the loop at the
end of the safety cable. The loop at the end of the
safety cable should just fit over the threads on the
wood screw. Test safety cable by pulling on loose end
of cable with pliers. If the safety cable slips, the loop
must be adjusted tighter. [Refer to diagram 7.]
Extra cable slack can be left in ceiling area.
downrod
canopy
canopy cover
yoke cover
motor assembly
diagram 5
diagram 6
wood
ceiling
joist
diagram 7
page 7
pin
set screw hole
stop pin
canopy
safety cable loop
hanging bracket tab
hanging ball slot
motor
assembly
Allen wrench
set screw
hanging ball
wood screw
and washer
safety cable