13. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the 2 different fan speed buttons
/
. When
changing fan speed, the small LED lights at the top
of the remote control will light to indicate current
fan speed (1 - 6). Test the light ON/OFF function by
pressing the
button; test the dimmer function by
pressing the
button and holding it down for up
to 5 seconds. Test the CCT button for the different
LED colors. [Refer to Section 11 for different levels.]
If the remote control operates all of the functions of
the fan and light, the battery has been installed
correctly. If the remote control does not operate all
of the fan/light functions, refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Fan must be on LOW before setting the fan to
reverse direction. Use the
button to recirculate
air depending on the season. A ceiling fan will allow
you to raise your thermostat setting in summer and
lower your thermostat setting in winter without
feeling a difference in your comfort.
NOTE: If the remote control interferes with other
appliances, turn power off first and then go back to
the instructions in Section 10, page 10.
IMPORTANT: Remote control must be
synchronized with fan in order to properly function.
page 12