Craftmade Levy LVY24 Guia De Instalacion página 6

5. Fan Assembly.
Locate small Allen wrench provided in hardware
pack. Use Allen wrench to loosen pin in yoke at top
of motor assembly and then remove it by pulling it
out. If necessary, partially loosen set screws on yoke
at top of motor assembly. [Refer to diagram 1.]
Place LED light kit (flat side down) on clean, flat
surface that will not damage the LED ring. Locate all
rod screws, Allen screws and large Allen wrench in a
hardware pack--these will be used for installation of
rods.
Partially install all Allen screws into LED light kit and
top of motor assembly as shown in drawing at right.
[Refer to diagram 2.]
NOTE: Be sure to install Allen screws with open end
out so as to have access with Allen wrench later on.
Install rods by observing the arrows on each
one--use the arrow on each rod to align with the
arrow on the rod holder on the LED light kit. Once
aligned, use rod screws to attach rods (one by one)
to the LED light kit. [IMPORTANT: Install all 4 rods
onto the LED light kit BEFORE starting to attach
rods to the motor assembly.] 2 of the rods will
simply be attached, the other 2 rods will require
that the wiring from the LED light kit be threaded
through the rod first. [Refer to diagram 3.]
When ready to attach the rods to the motor
assembly, it is advisable to connect the molex
connection from the two rods that have wiring
first--this will make it easier to align the rest of the
rods with the motor assembly. Lastly, tighten each
Allen screw to secure the LED light kit to the motor
assembly. [Refer to diagram 4.]
Once all 4 rods have been attached to LED light kit
and motor assembly, securely tighten all Allen
screws.
WARNING: Failure to tighten Allen screws
securely may cause personal injury or damage to
the product.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 4.]
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
yoke
diagram 1
Allen wrench
(large)
open
end
out
Allen screws
Allen wrench
(large)
diagram 2
rod
rod screw
screw
align arrows
diagram 3
molex
connection
LED light kit
diagram 4
page 6
set screw
pin
motor
assembly
Allen screws
motor
assembly
open
end
out
Allen screws
LED light kit
wiring
rod
rod
rod holder
LED light kit
electrical wires
rod
motor
assembly
Allen wrench
(small)
Allen screws
Allen wrench
rod
screws
*