Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Discharge
n holes here
Figure 2
Secure bottom hole on the handle to the snow
thrower frame using 5/16 x .75" hex bolt and lock
washer from the hardware
pack (group A on page
5 ). Do not tighten at this time. See Figure 3.
Attach
handle
tab here
Atta_ch lock washer
and hex bolt here
NOTE:
The right wheel
and drive
cover have been removed
from picture
here for viewing
clarity,
Figure 3
•
Place a handle tab, included in the hardware
pack
(group A on page 5), over the upper hole in handle
so that the contour of the handle tab matches that
of the handle. See Figure 3.
•
Secure handle tab to the snow thrower using hex
bolt (5/16 x 2.0" long) and lock washer from the
same group in the hardware
pack. Do not tighten
at this time.
•
Attach the left handle in the same manner. Do not
tighten at this time.
Attaching
Chute
•
Place the chute assembly over the chute opening
with the chute facing front of the unit.
NOTE:
Make
sure
that
the
chute
cables
are
straightened
while assembling
the chute.
•
Place the chute flange keeper (flat side down)
beneath lip of chute assembly as shown in Figure
4 .You will find the chute flange keepers in group E
of the hardware pack.
•
Insert hex bolt (1/4-20 x .75") and flange nut from
group E up through chute flange keeper and chute
assembly as shown in Figure 4. Do not tighten at
this time. Rotate chute to install all flange keepers.
Chute
/
Hex
Bolt
Hex
Range
\
Chute
Flange
\
Keeper
\
Figure 4
After assembling
all three chute flange keepers,
tighten, then back off 1/4 turn to allow easier
movement
of the chute. Use (2) 7/16" wrenches.
Attaching
Chute Crank
•
You may have to loosen the carriage bolts and
hex lock nuts which secure the lower chute crank
bracket to the extension
on the left side of the
chute assembly.
See Figure 5.
Lwr
h _
Figure 5
•
Place one 3/8 ID flat washer (from group F of the
hardware
pack) on the end of the chute crank,
Publicidad
Tabla de contenido
