Cherubini BLUE WAVE RX Serie Manual De Instrucciones página 41

elecTric wiring To moTor command for up-down mode
To connect the switch, use only kind of switches with mechanical or electrical interlock, to
prevent to press both buttons at same time.
230 V 50 Hz
4
nOTES FOR THE BLUE wAvE RX Ø 35 mOTOR
In the Ø35 version the motor automatically recognizes the switch-type (with 1 or 2 buttons)
and sets the proper operational mode. Following the automatic recognition and after the
wire setting, if required the motor changes the association of the switch buttons to adapt
them to the correct drive direction (Up - Down). At this point, if the drive direction does not
match with the buttons, the motor resets the proper association upon the first complete Up/
Down cycle. During this cycle the motor performs a technical stop and then automatically
starts back up.
In the Ø35 version motor, using the switch as described on this page it's possible to set the
motor trough the white wire (wire programming). To find out this procedure, require the
instruction pamphlet from your dealer.
(2 independent up-down buttons)
Switch with mechanical
or electrical interlocking
1
3
2
41
1 - BROwn
2 - wHITE
3 - BLUE
4 - yELLOw-GREEn