cecotec DRUMFIT INDOOR 6000 COMPACT Manual De Instrucciones página 51

- The console automatically switches off when no signal is sent from the speed sensor or if
the button is not pressed for 4 minutes.
Reset button
- The machine can be reset by pressing the button for 3 seconds or changing the batteries.
Functions
- To display one function or another, press the MODE button until the desired function
appears on the display.
TIME: Displays total workout time (0:00-99:59)
SPEED: Displays the current speed (0.0-999.9)
DISTANCE: Displays run distance on every training session. (0.0-999.9)
ODOMETER: Displays the total accumulated distance since a battery change. (0-9999)
CALORIES: Displays the calories burned during the training session. (0.0-999.9)
SCAN: Displays the functions one by one automatically.
5. CLEANING AND MAINTENANCE
- Lubricate the moving parts periodically to prevent premature wear.
- Inspect and tighten all parts before using the machine. Replace any defective parts
immediately, and do not use the equipment again until it is in perfect working condition.
- The machine can be cleaned using a slightly damp cloth and mild non-abrasive detergent.
Do not use solvents.
- Avoid exposing the machine to direct sunlight, especially the console.
- Do not try to repair the machine by yourself. Should you have any difficulty with the
assembly or operation of the exercise bike, or if you think that any part is missing, contact
the official Cecotec Technical Support Service.
- To move the machine, either pull down on the handlebars until the rear of the bike is in the
air or lift the bike by grasping the rear stabiliser. This allows you to move the bike to the
desired position in complete safety.
Note:
The cleaning and maintenance frequency depends on the use frequency and intensity.
6. INFORMATION ON EXERCISING
A proper workout should consist of the following three phases:
Warm-up: consists of a session of stretching and low-intensity exercise lasting 5 to 10
DRUMFIT INDOOR 6000 COMPACT
ENGLISH
51