Num'axes PIE 1013 Manual De Instrucciones página 38

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

programmable setting (MAN).
When the power switch is in the TEST position, the camera will power
off after 5 minutes without operation.
Setting the Preset Selection Mode
NOTE: If you choose one of the Preset settings, your camera
will only function in PIR mode (it will not function in Time
Lapse mode).
A (Preset A) - This bypasses all user
defined settings and uses the following
settings: PIR mode / Still image /
Resolution: 5MP / Burst: 3P (3 images
per trigger) / Time out: 30 seconds
B (Preset B) - This bypasses all user
defined settings and uses the following
settings: PIR mode / Video length: 10
seconds / Video resolution: 720P / Time
out: 30 seconds
Setting the Programmable Selection Mode
Your camera can be programmed to operate either in PIR Detection
mode or Time Lapse/PIR mode. When changing the settings, the switch
is in the TEST position then you have to slide it to MAN.
MAN - This allows the user to define what settings the camera
will use.
Passive Infrared
Mode
Setting the camera in PIR Mode
Slide the switch to the TEST position from OFF.
The status display will show the camera current status.
Press the [M] button once to enter the programming mode, the
word "PIR" or "TLS" will be blinking.
Indice A
Time-Lapse / PIR
Mode
38/144

Publicidad

Tabla de contenido
loading

Tabla de contenido