Getting Started - Num'axes PIE 1013 Manual De Instrucciones

button to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
•
Use the [▲], [▼] and [M] buttons to adjust all the latitude
digits.
•
The indication "LnG" is blinking on the LCD
screen. Press [M] once.
•
The "+" sign is blinking on the LCD screen. Press
the UP [▲] or DOWN [▼] button to select "+" for East or "-" for
West. Then press [M] once to confirm and move to the
longitude 1st digit setting.
•
The longitude 1st digit is blinking. Press the UP [▲] or DOWN
[▼] button to increase or decrease the value then press [M]
once to confirm and move to the next digit setting.
•
Use the [▲], [▼] and [M] buttons to adjust all the longitude
digits.
•
Once done, the word "SEt" will be blinking on the LCD screen.
•
Press and hold the [M] button for 2 seconds to exit.
Setting up the camera in the field
Once all program settings have been setup properly, your camera is
ready for field use.

Getting started

Listed below are some helpful pointers on how to use your camera to
get the best results.
•
Mount the camera about 1.5~2m (5~6 feet) high with the
camera pointed at a slight downward angle.
•
Mount the camera facing north or south NOT east or west as the
rising and setting of the sun could produce false triggers and
overexposed images.
•
If you're covering a trail, face the camera down or up the trail.
•
Clear out any brush or weeds in front of camera. These can
cause false triggers due to temperature and motions
disturbances in front of the camera (especially on windy days).
Indice A 46/144