Num'axes PIE 1013 Manual De Instrucciones página 40

•
Press the UP [▲] or DOWN [▼] button until the words "CAM"
and "burSt" are blinking.
•
Press [M] once to enter the burst shoot setting.
•
Press the UP [▲] or DOWN [▼] button to select the desired
burst mode setting (from 1P to 10P).
•
Press [M] once to save your selection. The words "CAM" and "T-
O" (Time Out) will be blinking. Press the [M] button once to
enter the time out setting or press and hold the [M] button for 2
seconds to exit.
Setting the video length in PIR mode
Your camera can be programmed to record from 5 seconds to
10 minutes (600 seconds) of video per trigger.
The video capture is available only under PIR mode.
•
After pressing [M] to confirm the PIR detection mode, press the
UP [▲] or DOWN [▼] button until "VIDEO" and "T".are blinking
on the LCD screen.
•
Press [M] once to enter the video length setting (from 005 to
600 seconds).
st
•
The 1
to increase or decrease the value then press [M] once to
confirm and move to the next digit setting.
nd
•
The 2
to increase or decrease the value then press [M] once to
confirm and move to the last digit setting.
rd
•
The 3
to increase or decrease the value then press [M] once to
confirm. "VIDEO" and "T-O" will be blinking. Press the [M]
button once to enter the time out setting or press and hold the
[M] button for 2 seconds to exit.
Setting the Time Out in PIR mode
You can select the length of time that the camera will "wait" until it
responds to any additional triggers from the PIR after an animal is first
Indice A
digit is blinking. Press the UP [▲] or DOWN [▼] button
digit is blinking. Press the UP [▲] or DOWN [▼] button
digit is blinking. Press the UP [▲] or DOWN [▼] button
40/144