Oven Installation
Note:
Before installing the oven, be sure to verify the cabinet
dimensions and electrical connections.
Removing the Oven Door
For ease of installation, some oven doors may be removed
to reduce the weight of the oven by 30 Ibs (14 kg) per door,
before installing into the cabinet. See instructions below.
,_
CAUTION:
When removing the door:
Make sure oven is cool and power to the
oven has been turned off before
removing the door. Failure to do so could
result in burns.
•
The oven door is heavy and fragile. Use
both hands to remove the oven door. The
door front is glass. Handle carefully to
avoid breaking.
•
Grasp only the sides of the oven door. Do
not grasp the handle as it may swing in
your hand and cause damage or injury.
•
Failure to grasp the oven door firmly and
properly could result in personal injury or
product damage.
•
To avoid injury from hinge bracket
snapping closed, be sure that both levers
are securely in place before removing the
door. Also, do not force door open or
closed - the hinge could be damaged and
injury could result.
•
Do not lay removed door on sharp or
pointed objects as this could break the
glass. Lay on a flat, smooth surface,
positioned so that the door cannot fall
over.
To remove
the oven door:
,
Be sure to read the
above CAUTION
before attempting to
remove the door.
2.
Open the door
completely.
3.
Flip levers on hinges
toward you.
4.
Holding the door firmly
on both sides and
using both hands,
close the door gently
until it stops against
the levers, about 30 °
from the closed
position.
5.
Carefully lift the door
up and out of the
hinge slots. Hold
firmly; the door is
heavy.
6.
Place the door in a
convenient and stable
location for cleaning.
Installing the Oven
1.
Lift or slide unit into cabinet cutout. Do not lift appliance
by door handle.
2.
Push straight in until oven trim is flush with cabinet
wall, being careful not to crimp flexible conduit between
oven and cabinet back wall. The oven should be
straight and level, not crooked.
3.
Install supplied screws through tap holes in trim. (2
screws for single ovens, 4 screws for double/combo
ovens)
English 11