Publicidad
Idiomas disponibles
Idiomas disponibles
The griddle is set and tested with liquid propane (LP) gas only. The regulator supplied is set for 27.94 cm (11 inch)
water column (WC) and is for use with LP gas only. The factory-supplied regulator and hose must be used with a 9 kg
(20 lbs) LP gas cylinder. Contact your gas supplier for a special regulator for bulk gas that fuels other appliances.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident there is excessive abrasion
or wear, or the hose is cut, the hose must be replaced prior to the appliance being used.
1.
Make sure the gas valve of the gas cylinder is closed.
2.
On the side of the unit with the retainer bracket, place a 9 kg (20
lbs) gas cylinder. Place the wire retainer onto the collar of the gas
cylinder and place the foot ring of the gas cylinder onto the gas
cylinder bracket to secure the gas cylinder in a fixed position. (A)
Ensure the gas cylinder is completely upright, as it is unsafe
to operate the grill if the gas cylinder is not level and in-
stalled properly to the unit.
3.
Ensure the Control Knobs of the griddle are completely closed by
turning the Control Knobs to the "O" (OFF) position. (B)
4.
Remove the protective caps from the gas regulator end and the
top outlet of the gas cylinder.
NOTE: Save the caps for when you need to switch to a new
gas cylinder, as you do not want damage and/or blockage to
your gas regulator end.
5.
Insert the gas regulator end onto the threaded top outlet of the
gas cylinder. Turn the quick coupling nut clockwise until firm.
Hand-tighten only. (C)
6.
The gas cylinder is now installed. (D)
The outdoor appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local codes with
the National Electrical Code ANSI/NFPA 70, or Canadian Electrical
Code, CSA C22.1.
1.
Do not store a spare gas cylinder under or near this appliance.
2.
Never fill a gas cylinder beyond 80 percent full.
3.
If the information in 1) and 2) is not followed exactly a fire
causing death or serious injury may occur.
4.
Place the dust cap on the gas cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on the
cylinder valve outlet that is provided with the cylinder valve.
Other types of caps or plugs may result in leakage of propane.
5.
The gas cylinder used must have a collar to protect the gas
cylinder valve outlet.
6.
Always keep the gas cylinder at 90 degrees (upright) orientation
to provide vapor withdrawal.
WWW.PITBOSS-GRILLS.COM
CONNECTING TO A GAS SUPPLY
GAS CYLINDER REQUIREMENTS
INSTALLING A GAS CYLINDER
17
A
C
D
B
PIT BOSS® GRILLS
Publicidad
