3M DBI-SALA 8300009 Instrucciones Para El Usuario página 15

Model Number (Serial Number):
Date Purchased:
;
This product must be inspected by the user before each use. Additionally, a Competent Person other than the user must
inspect this equipment at least once each year.
Component
Davit System
(Figure 2)
Anchor Connection Points
Labels (Figure 9)
Fall Protection Equipment
;
If the product fails an inspection procedure, then the product fails overall inspection. If the product fails inspection, remove
it from service immediately. Clearly tag the product "DO NOT USE". See Section 5 for more information.
Inspection Type:
Inspected By:
Signature:
Additional Notes:
Table 2 – Inspection and Maintenance Log
Inspection Procedure
Inspect the entire system for damage, deformation, corrosion, and rust.
Look for cracks, bends, dents, or wear that could affect strength and
operation of the system.
Inspect all fasteners for damage or corrosion. Tighten as necessary.
Inspect all moving parts for chips, cracks, breaks, or worn areas that can
cause malfunction during operation.
Verify that all adjustment points (pins, bolts, tri-screws, adjusting screws,
etc.) are in full functional condition and are properly adjusted.
Ensure Anchor Connection Points are free of corrosion, cracks, or other
imperfections that my cause malfunction during operation.
All labels are present and fully legible.
Additional Fall Protection equipment that is used with the product is
installed and inspected per the manufacturer instructions.
User Competent Person
Date of First Use:
···
···
···
···
Overall Inspection Result:
Date of Inspection:
Next Inspection Due:
···
Inspection Result
Pass Fail
Pass Fail