Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
- An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
- Particular care is due to the grease filter panel.
It can be removed by pushing its special handle
toward the back-side of the cooker hood and tur
ning the filter downwards so to unfasten it from
its slot (fig. 3).
To insert the filter just perform the opposite ope-
ration.
After 30 hours working, the push button control
panel will signal the saturation of the grease filter
by lighting all the buttons. Press the timer button
to reset
.
The grease filter needs cleaning by regular hand
washing or in dishwashers every two months at
least or depending on its use.
- In case the appliance is used in its filtering ver-
sion, the active coal filter (fig. 12) needs to be
periodically replaced. The coal filter can be remo-
ved by removing the grease filter first (fig. 3),
and by pulling its special plastic tongue until it is
unfastened from its slot.
Re-insert the coal filter by operating in the oppo-
site way.
The coal filter needs replacing depending on the
use, but however every six months at least.
How to remove the oil tank
After having removed the grease filters and even
tually the active coal filters, please hold the oil
tank up by one hand and ioosen the three han
dles by the other hand as showed in fig. 4. Then
let the tank slide downwards making attention in
order to avoid the leak of oil (fig. 5).
- To clean the appliance itself tepid water and
neutral detergent are recommended, while abra-
sive products should be avoided. For steel ap-
pliances specialized detergents are recommen-
ded (please follow the instructions indicated o the
product itself to obtain the desired results).
- Warning! To take down the appliance from the
cabinet, remove the definitive fixing screws (fig.
8) using a screw-driver, get off the grease filters
(fig. 3) and the active carbon filters, if they are
inserted (fig. 12).
Act on the small handle of the springs, which are
inside the built-in unit, with the necessary streng
th to unhook the appliance from the cabinet.
* If the supply cord is damaged, it must be re
placed by the manufacturer or its sevice agent
or a similarly qualified person in order to avoid
a hazard.
Substitution of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 13), disconnect it elec-
tronically using the appropriate connector then
substitute it with a LED bar with same charac-
teristics.
15
Publicidad
