Lomography Lomomatic 110 Instrucciones página 6

Installing the Battery:
The Lomomatic 110 requires 1 x CR2 (3V) battery to operate:
1. Slide the [1] Battery Door to the right to access the [2] Battery Chamber.
2. Install a CR2 Battery into the [2] Battery Chamber.
3. Close the [1] Battery Door by sliding it back in place.
4. Hold the left and right sides of the Lomomatic 110 with both of your hands and
slide the camera open to turn it on. With the battery correctly installed, you
will see the [3] ISO Indication Light illuminated at ISO 200 as default.
[2]
6
Note: if the camera is left switched on for more than 5
minutes, it will automatically go into sleep mode. To turn
[4]
it back on again, simply close and reopen the camera or
[3]
press any button.
[1]