Safety; Intended Use - WIKA S-20 Manual De Instrucciones

2. Safety

2. Safety
WARNING!
Before installation, commissioning and operation, ensure that the appropriate pressure transmitter has been
GB
selected in terms of measuring range, design and specific measuring conditions.
Non-observance can result in serious injury and/or damage to the equipment.
WARNING!
Open the connections only after the system has been depressurised.
■
Observe the working conditions in accordance with chapter 3 "Specifications".
■
Further important safety instructions can be found in the individual chapters of these operating instructions.

2.1 Intended use

The pressure transmitter is used to convert pressure into an electrical signal.
With hydrogen applications, use is only permitted when a medium and ambient temperature of 30 °C is not exceeded.
For applications with direct contact with foodstuffs this pressure transmitter is not suitable.
The instrument has been designed and built solely for the intended use described here, and may only be used
accordingly.
The technical specifications contained in these operating instructions must be observed. Improper handling or opera-
tion of the pressure transmitter outside of its technical specifications requires the instrument to be taken out of service
immediately and inspected by an authorised WIKA service engineer.
The manufacturer shall not be liable for claims of any type based on operation contrary to the intended use.
6 WIKA operating instructions pressure transmitter, model S-20