Campingaz IR 5000 Instrucciones De Empleo página 9

index between positions (III) and (I) (3: see fig. 5 - IR
5000 - item A
and - IR 5000 Turbo - reference A)
b) Exclusive to IR 5000 Turbo Version
After lighting up your appliance in compliance with
the indications of paragraph E-1, you can increase its
heating performance by means of the ''Turbo" function.
The "Turbo" function provides for fast and even heating
of the room because it uses a tangential ventilation to
propel the hot air now out of the appliance.
The "Turbo" function is turned on / off by pressing the
red button (fig. 5 - IR 5000 Turbo - item C).
CAUTION:
The appliance was designed to be supplied with a
230 V 50 Hz voltage.
Your installation must be equipped with a grounding
connection compliant
specifications in force.
c) IR 5000 Thermo Version
- Set the heating temperature by positioning handle
index between positions maximum (IIII) and
minimum (I) (see fig. 5 - IR 5000 Thermo - item C)
E - 3 - SHUTTING DOWN THE APPLIANCE:
- Close bottle cock and/or gas pressure reducing valve handle.
THIS APPLIANCE IS EQUIPPED WITH AN ATMOSPHERE
ANALYSER DEVICE WHICH AUTOMATICALLY TURNS
OFF THE APPLIANCE SHOULD THE ROOM CONTAIN
TOO HIGH A CARBON DIOXIDE PERCENTAGE (CO
IN THIS CASE, THOROUGHLY VENTILATE THE ROOM,
OTHERWISE THE APPLIANCE WILL NOT RELIGHT.
F - REMOVING OR REPLACING THE GAS BOTTLE
- Check that gas bottle cock and/or pressure reducing
valve handle is in the closed position.
- Open appliance rear plate (fig. 4 item B) and remove the bottle
from its housing, taking care not to pull or bend the hose.
- Disconnect pressure reducing valve from gas bottle.
- Install the new gas bottle and carry out a leak test as
described under paragraphs D-1 and D-2.
G - STORAGE - SERVICING
1) Appliance
When it is not used, the appliance should remain open
and be stored in a dust-free place.
- Remove stains with soapy water, when the appliance
is cold. Wipe off with a cloth.
- Do not use abrasives which might damage the
paintwork.
- For heavy repairs, please call your vendor.
- The appliance should be checked periodically, at
Defects
The burner does not light up
The burner misfires or turns off
Unstable blowing flames
The pilot burner does not light up
with electrical systems
2
Defects / Remedies
least once a year and every time the gas bottle is
replaced; particularly, the state of the fitted gas
hose should be checked at that time.
2) Hose between the pressure reducing valve and
the appliance
- Please check periodically, at least once a year
and each time the gas bottle is replaced, the state
of the fitted gas hose and replace it if it shows
any signs of damage or any cracks.
- The hose must be replaced by a new one of same
length and equivalent quality.
- The hose must be replaced in compliance with
the above-mentioned periodicity for the respective
countries.
- In France, if the expiry date printed on the hose is
reached, it must be replaced by a hose compliant
with the XP D 36-112 Standard.
- Comply with installation indications provided with
these new assemblies to be 0.50 m long, and with
the procedure described under paragraph C - 2.
- If your appliance is to remain unused for a long
period, disconnect gas bottle
3) Electric supply cable (IR 5000 Turbo model)
- All damaged cables must be replaced by the
).
manufacturer, its after-sales service or a similarly-
qualified person, to avoid danger.
H - PROTECTING THE ENVIRONMENT
Think about protecting the environment! Your equipment
contains materials which can be recovered
or recycled. Hand them in to the waste
collection service in your municipality and
sort the packing materials.
I
ELECTRONIC WASTE
This symbol means that the appliance's
electrical system must be disposed of selectively. At the
end of its life, the appliance's electrical system must be
scrapped correctly. The electrical system must not be
disposed of with unsorted municipal waste. Selective
collection of waste promotes reuse, recycling or other
forms of recovery of recyclable materials contained in
this waste. Take the appliance's electrical system to a
waste recovery centre designed for the purpose (waste
collection point). Check with your local authorities. Never
dispose of in nature, do not incinerate: the presence of
certain hazardous substances in electrical and electronic
equipment can be harmful to the environment, and have a
potential effect on human health.
Probable causes / remedies
- Poor gas feed
- Pressure reducing valve inoperative
- Check for gas level in bottle
- Check for gas level in bottle
- Check hose connection
- Call technical support
- New bottle. Allow to operate, the defect will disappear
- Call technical support
- Pilot burner clogged
- Call technical support.
9
- ELECTRICAL
GB
AND