GreenWorks Commercial UTV 800 Manual Del Usuario página 21

CODE FAULT
0012 Controller Overcurrent
0013 Current Sensor Fault
0014 Precharge Failed
0015 Controller Severe Undertemp
0016 Controller Severe Overtemp
0017 Severe Under voltage
0018 Severe Overvoltage
0022 Controller Overtemp Cutback
0023 Under voltage Cutback
0024 Overvoltage Cutback
0025 (+5V) Supply Failure
0026 Digital Out 6 Open/Short
0027 Digital Out 7 Open/Short
Digital
0028 Motor Temp Hot Cutback
0029 Motor Temp Sensor Fault
0031 Main Open/Short
0032 Coil2 Driver Open/Short
0033 Coil3 Driver Open/Short
0034 Coil4 Driver Open/Short
0035 PD Open/Short
0036 Encoder Fault
0037 Motor Open
0038 Main Contactor Welded
0039 Main Contactor Did Not Close
FAULT CODE
OPERATOR FIX
If machine is operating under heavy load, reduce load
with lower speed drive.
Cycle KSI
Cycle KSI
Cycle KSI
Bring unit into warm environment and allow the
machine and battery to warm up.
Stop vehicle and allow to cool down. If operating in a
hot environment, wait until temperature cools down.
Check battery wires and connections;
Check fuse state and main contact connections.
Cycle KSI
Stop vehicle and wait to the Controllers cool down. If
operating in a hot environment, wait until temperature
cools down.
The battery voltage is too low
Check battery wires and connections;
Check fuse state and main contact connections.
Cycle KSI
External load impedance is too low.
External load impedance is too low.
External load impedance is too low.
Stop vehicle and wait to cool down. If operating in a
hot environment, wait until temperature cools down.
Motor thermistor is not connected properly or moter
temp sensor failure
Open or short on driver load.
Open or short on driver load.
Open or short on driver load.
Open or short on driver load.
Open or short on driver load.
Motor encoder failure.
Bad crimps or faulty wiring.
Check motor phase
Bad crimps or faulty wiring.
Main contactor failure
Main contactor failure
21