GreenWorks Commercial UTV 800 Manual Del Usuario página 22

0041 Throttle Wiper High
0042 Throttle Wiper Low
0043 Pot2 Wiper High
0044 Pot2 Wiper Low
0045 Pot Low Overcurrent
0046 EEPROM Failure
0047 HPD/Sequencing Fault
0048 Emer Rev HPD
0049 Parameter Change Fault
0053 HPD Fault
0054 Battery BMS Fault
0055 BMS PDO Fault
0056 Battery Cell UnderVoltage
Fault
0068 VCL Run Time Error
0069 External Supply Out of Range
0071 OS General
0072 PDO Timeout
0073 Stall Detected
0077 Supervisor Fault
0078 Supervisor Incompatible
0087 Motor Characterization Fault
0088 Encoder Pulse Error
0089 Motor Type Fault
0091 VCL/OS Mismatch
FAULT CODE
1.Throttle failure.
2.Check the connections of Throttle.
1.Throttle failure.
2.Check the connections of Throttle.
1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
1.Electric Putter (Electric height adjustment module)
sensor failure;
2.Check the connections of Electric Putter.
Cycle KSI.
Reapply input s in correct sequence.
Reapply input s in correct sequence.
Cycle KSI.
Reapply inputs in correct sequence.
1.Check the battery voltage ;
2.Restart vehicle;
3.Replace battery and contact dealer.
Cycle KSI
Cycle KSI
Edit VCL application software to fix this error condition;
flash the new compiled software and matching
parameter defaults; cycle KSI.
Bring the external supply current within range.
Cycle KSI.
Cycle KSI or receive CAN NMT message.
Stalled motor.
Motor encoder failure
Check for noise or voltage drift in all switch inputs;
check connections;cycle KSI.
Load properly matched OS code or update the
Supervisor code; cycle KSI.
Correct fault; cycle KSI.
Ensure the Encoder Steps parameter matches the
actual encoder; cycle KSI.
Set Motor_Type to correct value and cycle KSI.
Download the correct VCL and OS software into the
controller.
22