Publicidad
Idiomas disponibles
Idiomas disponibles
Seat Belts
This GREENWORKS vehicle is equipped with three- point lap and diagonal seat belts for the
operator and passenger. Always make sure the seat belts are secured for all riders before
operating. The center of the seat is NOT equipped with a seat belt. Never allow a passenger to ride
between the operator and passenger seats.
Falling from a moving vehicle could result in serious injury or death. Always fasten your seat
belt securely before operating or riding in the vehicle. To wear the seat belt properly, follow this
procedure:
1. For 3-point belts, pull the seat belt latch downward and across your chest toward the buckle at
the inner edge of the seat. The belt should fit snugly across your hips and diagonally across your
chest. Make sure the belt is not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self tighten.
4. To release the seat belt, press the square red button in the buckle's center.
Buckle
Seat Belt Inspection
If the seat belts are not secured, the UTV can only be operated at low speed!
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly into the
buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including cuts, wear,
fraying or stiffness. If any damage is found, or if the seat belt does not operate properly, have the
seat belt system checked and/or replaced by an authorized GREENWORKS dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water. Do not use
bleach, dye or household detergents.
FEATURES AND CONTROLS
Latch Plate
WARNING
26
Publicidad
