GreenWorks Commercial UTV 800 Manual Del Usuario página 41

Gear cases
Gear case Specification Chart
Gear case
Main Gearcase
(Transaxle)
Front Gearcase
Main Gearcase (Transaxle)
Always check and change the main gearcase oil at the intervals outlined in the Periodic
Maintenance Chart. Maintain the oil level even with the bottom thread of the fill plug hole.
Refer to the Gearcase Specifications Chart for recommended lubricants, capacities and torque
specifications.
Oil Check
The fill plug is located at the right rear of the vehicle.
1. Position the vehicle on a level surface.
2. Remove the fill plug.
3. Check the oil level.
4. Add the recommended oil as needed.
5. Reinstall the fill plug. Torque to specification.
Oil Change
The drain plug is located on the lower right side of the
main gearcase, near the fill plug. Refer to the Gearcase
Specifications Chart
capacities and torque specifications.
1. Remove the fill plug.
2. Place a drain pan under the drain plug. Remove the
drain plug. Allow the oil to draincompletely.
3. Wipe the magnetic end of the drain plug clean to
remove accumulated metallic filings.
4. Reinstall the drain plug. Torque to specification.
5. Add the recommended oil as needed. Do not overfill.
6. Reinstall the fill plug. Torque to specification.
7. Check for leaks. Dispose of used oil properly.
MAINTENANCE
Lubricant
ATV Angle Drive
Fluid
Demand Drive
Fluid
for recommended
Capacity
30.4 oz. (900 ml)
5.1 oz. (150 ml)
lubricants, Fill plug
41
Capacity
Fill Plug Torque
14 ft. Lbs. (19.4
Nm)
8-10 ft. lbs. (11-
13.6 Nm)
Drain plug
Drain Plug
Torque
14 ft. Lbs. (19.4
Nm)
11 ft. lbs. (15
Nm)
Fill plug
Drain plug