Publicidad
Idiomas disponibles
Idiomas disponibles
Operation of the machine
Remove all foreign objects from the work area before using the machine. Stones, glass, branches,
and similar items can damage the rudder. Also check that the rudder bolts are tightened.
Start the engine according to the instructions below. Stay away from moving parts of the
machine.
Never attempt to move the machine in any manner other than that intended for normal use
while the engine is running.
Drive
Follow the operation procedure as shown in Figure 5:
A-1
Activate your team
A-2
Adjust the throttle
A-3
Choose the driving direction (B - R)
A-4
Activate the clutch handle
Differential
Activate the differential lever, see Figure 6. The differential system helps the machine rotate
easily. But both wheels can lock if the wheels slip or if the machine needs to go in a straight line.
PTO (coupling an accessory)
To activate an accessory, see Figure 5 (A-1).
Pay attention when reversing. It is important that the area is clear, due to any obstacles, before
reversing. Never reverse the rudder against a wall, tree, or any other fixed obstacle.
Assembling an Accessory
Switching from front-mounted to rear-mounted accessories
Follow the assembly procedure shown in Figure 7,
Step 1-6:
1. Place the gear in the neutral N position and release the 2 shifter rods from the lock
under the handlebars:
2. PTO shifter (right side when in front mount position)
3. Shifter (left side when in front mount position)
4.Remove the right rod from the PTO shifter (A) by removing the spring clip (C). Pull up
the tube (B) from the PTO fork shaft (D) and then rotate the tube 180°.
5.Push down on the handle lock (A) and turn the handle 180°.
6.
Replace the PTO shifter rod (A) with the spring clip.
126
Publicidad
