Installation; Installation Room; Ambient Temperature; Ventilation - Gaggenau RC 462 Manual De Uso Y De Cuidado

Installation

m
WARNING
Do not install the appliance:
– outdoors,
– in an environment with dripping water,
– in rooms which are at risk of frost.
The appliance is very heavy – for empty weight see
the following table:
Refrigerator 24"
Refrigerator 30"

Installation room

Install the appliance in a dry, well ventilated room.
The installation location should neither be exposed to direct
sunlight nor near a heat source, e.g. a cooker, radiator, etc.
If installation next to a heat source is unavoidable,
use a suitable insulating plate or observe the following
minimum distances to a heat source:
1
– 1 / " (3 cm) to electric or gas cookers.
4
– from an oil or solid-fuel cooker 11

Ambient temperature

The climatic class can be found on the rating plate.
It states the room temperature within which the appliance
can be operated.
Climatic class
SN
N
ST
T

Ventilation

Never cover the ventilation openings in the base panel. The
cooling motor otherwise has to increase its output, and this
increases the electricity consumption.
8
310 Ibs/140 kg
350 Ibs/158 kg
13
/ " (30 cm).
16
Permitted ambient temperature
+50 °F to 89.6 °F
(+10 °C to 32 °C)
+60.8 °F to 89.6 °F
(+16 °C to 32 °C)
+60.8 °F to 100.4 °F
(+16 °C to 38 °C)
+60.8 °F to 109.4 °F
(+16 °C to 43 °C)
m

Installation cavity

It is important to observe the specified dimensions
of the installation cavity for a trouble-free installation
of the appliance and for the subsequent general view
of the furniture front.
In particular ensure that the cavity is square.
Squareness can be checked by suitable means, e.g. spirit
level, diagonal measurements, etc.

Furniture/Fixtures

The new appliance will be mounted securely to adjacent and
overhead furniture/fixtures.
For this reason it is essential that all attachable furniture/
fixtures are connected securely to the base or the wall
by suitable means. If making structural changes fix the
appliance in place again corresponding to the installation
instructions.

Base

To ensure that the appliance is installed securely and
functions properly, the base must be flat and level.
The base must be made of hard, rigid material.
The installation area must be the same height as the rest
of the room.
On account of the heavy weight of a fully loaded appliance,
a load-bearing base is required.
For fully-loaded weight see the following table:
– Refrigerator 24"
– Refrigerator 30"
If in doubt, contact an architect or a building expert.
890 Ibs/400 kg
1110 Ibs/500 kg