Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points
below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot
be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
Symptom
¶ The power plug is disconnected from the outlet.
The power does not
turn ON.
¶ Due to effects of static electricity when the air is
The unit does not
work even when the
buttons are pressed.
¶ Not properly connected.
No Sound is output
¶ Sound is muted.
when a function is set.
¶ The volume is turned down.
¶ The cause may lie in the protector circuit.
¶ Not received at proper frequency.
Considerable noise in
¶ The antenna is not connected.
radio broadcasts.
(FM broadcast reception)
¶ The FM antenna is not stretched out, and faces
¶ Weak radio waves.
(AM broadcast reception)
¶ The AM antenna faces inappropriate direction.
¶ Weak radio waves.
¶ Affected by other equipment. (Fluorescent lamp,
¶ Surround or center level is turned down.
No sound from sur-
round or center speaker.
¶ The surround or center speaker is disconnected.
¶ The remote control unit batteries have worn out.
Cannot be remote
¶ Too great of a distance. Bad angle.
controlled.
¶ There is an obstacle blocking signals in between.
¶ Strong light such as fluorescent light is shining
If the unit does not operate normally due to external effects such as static electricity, disconnect the power plug
from the outlet and insert again to return to the normal operating conditions.
Cause
dry.
an inappropriate direction.
motor, etc.)
onto the unit's remote sensor.
OTHER
Remedy
¶ Insert into the wall outlet.
¶ Disconnent the power plug from the
outlet, and insert again.
¶ Refer to pages 13- 15 and connect
again.
¶ Press the MUTING button on the
remote control unit.
¶ Adjust MASTER VOLUME.
¶ Connect the speaker cords again.
(P.14,15)
¶ Receive the correct frequency.
¶ Connect the antenna properly.
(P.13, 14)
¶ Stretch out the antenna and secure
it to a wall while selecting the direc-
tion and position with the best recep-
tion state.
¶ Change the FM antenna to an outdoor
antenna of multiple elements. (P.13)
¶ Select the direction and position with
the best reception state.
¶ Connect the AM outdoor antenna. (P13)
¶ Turn off the equipment which cause
noise or move them away from the unit.
¶ Distance the antenna from the equip-
ment which cause noise.
¶ Select the correct center mode. (P.18)
¶ Raise the level.(P.18)
¶ Connect (P.14, 15)
¶ Replace the batteries. (P.7)
¶ Operate within 7m and 30 deg. from the
left and right of the remote sensor.
¶ Remove the obstacle or operate from
somewhere else.
¶ Avoid direct exposure of the remote
sensor to the light.
33
En
Publicidad
