CHECKING ACCESSORIES
FM antenna
RCA Cable
AM loop antenna
Remote control unit
REMOTE CONTROL UNIT
Loading Remote Control Batteries
1 .
2 .
CAUTIONS
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions.
¶ Never use new and old batteries together.
¶ Insert the plus and minus sides of the batteries properly
according to the marks in the battery case.
¶ Batteries with the same shape may have different volt-
ages. Do not use different batteries together.
AC adaptor Plug
Dry Cell battery
(size "AA" IEC R6P) × 2
Dry cell battery
(size "AA" IEC R6P)
2
x
Operating Range of Remote Control Unit
¶ The remote control unit may not work if there are
obstacles between the remote control unit and this unit,
and if the remote control unit is not directed toward the
remote sensor of the main unit at the correct angle.
¶ The remote control unit may not work properly if strong
light such as direct sunlight and fluorescent light is
shining onto the main unit's remote sensor.
¶ The remote control unit may not work properly when this
unit is used near devices emitting infrared rays, or when
remote control units of other devices which use infrared
rays are used.
On the other hand, the use of this remote control unit
may cause other devices to work improperly.
¶ When the operating range of this remote control unit
becomes too short, replace the batteries.
Operating the Remote Control Unit
By connecting the control cord (optional), other PIONEER
products can be operated using this remote control unit via
this unit. Direct the remote control unit towards the remote
sensor of this unit.
The remote control signals are received by the remote
sensor of this unit, and sent to the other devices via the
CONTROL OUT terminal.
BEFORE USE
7
En