Publicidad
Idiomas disponibles
Idiomas disponibles
.. Using the Sync Finish function
The Sync Finish function is used for preparing different foods with a different cook-
ing temperature and cooking time. Both foods will finish cooking at the same time.
Press the standby button
Press the zone selection button (32) to configure the settings for fryer drawer
(18).
Configure the settings for fryer drawer 1 (18) as described above.
Press the zone selection button (27) to configure the settings for fryer drawer
(15).
Set the cooking time and cooking temperature or an automatic programme for
fryer drawer (15) as described above.
Press the
SYNC FINISH (34) button to select the Sync Finish function.
Start the cooking process by pressing the
The cooking process starts for both fryer drawers with the respective settings. The
SYNC FINISH buttons (34) flash during the cooking process.
and
.. Recommended settings
The quantities or numbers of pieces in the table below represent the op-
timum and maximum quantity.
Refer to the table for the corresponding settings for the respective food.
The settings may vary by volume, by the food itself or by your own wish-
es and taste. Also observe the preparation instructions from the respec-
tive food manufacturers.
Larger quantities of food usually require a slightly longer cooking time,
smaller quantities, a slightly shorter cooking time.
To achieve optimal cooking results, shake the fryer drawer (15/18)
(see Fig. G) or turn the food (see Fig. H) several times throughout
the cooking process as required.
Optimum
weight (g)
Food
Maximum
weight (g)
Thin-cut frozen
chips
Small cakes
(30) to switch on the air fryer.
Time
(min.)
500
24
640
25
300
25
button (29).
Temp.
(°C)
Preheat for 3 minutes
180
Shake 3–4x
180
Use baking tin, approx. 6
160
muffins
Do not tilt/flip
Note
195
DE
FR
NL
ES
IT
EN
Publicidad
