Publicidad
Idiomas disponibles
Idiomas disponibles
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND
OPERATION
Action
Saw blade Assembly and
Removing
Safety On/Off Switch
NOTE: Keep the dust adapter
connected to dust collecting
device when using the tool.
Sawdust Removal
Cross and Rip Cutting
Parallel Guide
Cutting Depth Adjusting
Pocket Cutting
14
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the
motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock.
Cutting with extreme force can significantly
reduces the performance capability of the tool and
reduces the service life of the saw blade. Sawing
performance and cutting quality depend essentially
on the condition and the tooth count of the saw
blade. Therefore, use only sharp saw blades that are
suited for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very
fine cuts into delicate surfaces, diamond for tile,
cement board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords
Electric Circular Saw
periodically and if damaged, have repaired by
authorized service facility. Your power tool requires
no additional lubrication or maintenance. There are
no user serviceable parts in your power tool. Never
use water or chemical cleaners to clean your power
tool. Wipe clean with a dry cloth. Always store your
power tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Figure
Periodically clear dust and chips from guard and
base to ensure proper performance.
See Fig. A
ENVIRONMENTAL
See Fig. B
PROTECTION
See Fig. C
See Fig. D1, D2
local authorities or retailer for recycling advice.
See Fig. E1, E2
See Fig. F1, F2
See Fig. G1, G2,
G3, G4, G5
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
EN
Publicidad
