Worx WX423 Serie Manual Original página 15

TROUBLE SHOOTING
Symptom
Tool will not start when operating
the on/off switch.
Cutting depth is less than that
is set.
Blade spins or slips
Blade will not cut a straight line.
Blade kicks back when beginning
a cut
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
Declare that the product,
Description Worx Electric Circular Saw
Type WX423 WX423.X (4-designation of machinery,
representative of Saw)
Function Cutting various materials with a rotating
toothed blade
Complies with the following Directives,
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to:
EN 62841-1, EN 62841-2-5,
EN IEC 55014-1, EN IEC 55014-2
EN IEC 61000-3-2, EN 61000-3-3,
EN 60745-1, EN 60745-2-22, EN IEC 63000
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
Electric Circular Saw
Possible Causes
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn down
Sawdust accumulated at the
rear of the base.
Blade is not tightly engaged
with the spindle.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
2019/08/21
Allen Ding
Deputy Chief Engineer,Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
Possible Solution
Check to make sure power cord is
connected well into a working outlet.
Unplug the power cord. Replace it
using a qualified maintenance person.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and reassemble it
as described in Saw blade Assembly
and Removing section.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Allow the saw blade to reach full
speed prior to beginning a cut in the
material.
15
EN