Publicidad
» Fig�1
» Fig�2
» Fig�3
5.2
DIMENSIONAL UNIT ASSEMBLY
Ū Use the dimensional drawings to determine the position of
the suspension rods (Fig.4 AQ 10-20-30-35) (Fig.5 AQ 40-
50-60)
Ū Position the suspension rods (not supplied) in place.
Ū Attach the supplied brackets (Fig.6 ) to the suspension rods
(Fig.7 ). The length of the suspension rods depends on the
space between the suspended ceiling and the structural
ceiling.
Ū The distance C (Fig.7 ) must be:
Model
ACQVARIA 10-20-30-35
ACQVARIA 40-50-60
Ū Pay attention to the excess length B of the suspension rod
C- Bracket distance to the false
ceiling
270
312
(Fig.7 ): it may interfere with the unit's electrical box.
Ū Place the fan coil unit in the suspended ceiling, orienting
the side with the water connections in the most appropriate
position, using the hooks on the brackets to provide quick
temporary installation.
Ū Then attach the unit to the threaded bars with the screws
provided and check that it is level (Fig.8 )
Ū Adjust the distance between the unit and suspended ceiling
D (Fig.9 AQ 10-20-30-35 andFig.10 AQ 40-50-60 AQ 40-50-
60) using the nuts of the suspension rods:
Model
ACQVARIA 10-20-30-35
ACQVARIA 40-50-60
Ū Make sure that the unit does not touch the ceiling: contact
may cause noise.
Ū Insulate the brackets (fig. 6) fixed on the unit with the insu-
lation supplied.
» Fig�4 AQ 10-20-30-35
» Fig�5 AQ 40-50-60
D - Distance from unit to false
ceiling
23
48
WC66000482-06
35
Publicidad
