Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Maintenance
Maintenance regulations
Interval
Regularly
(before use,
at the start of
the working
day)
Every six
months
After two
years at the
latest, in
accordance
with the
information
on the
service
sticker.
28
Maintenance work
▶ Check the pressing tool
and mains cable for
externally visible defects
and damage that could
affect safety.
▶ Clean and lubricate the
pressing tool.
▶ Clean pressing
attachments and check
for defects, particularly
for cracks in the
material.
▶ Lubricate the pressing
attachments. → See
user manual for the
Geberit pressing
attachments in question.
▶ Have an authorised
repair shop perform a
test for safety-related
defects or damage.
However, this metro-
logical measurement
does not replace any
country-specific
regulations and legis-
lation that might
prescribe further checks
and maintenance work.
▶ Have an authorised
repair shop check the
press capacity and the
state of wear.
Cleaning and lubricating the
Geberit pressing tool
WARNING
Risk of fire from short circuit
▶ Never clean the pressing
tool with water or other
liquids.
1
Disconnect the mains plug.
2
Clean the roller drive, roller drive
guide and retaining pin of the
pressing tool.
3
Use a brush to remove dirt.
CAUTION
Harmful substances
▶ Observe the safety notes of
the lubricant used.
4
Lubricate the roller drive, roller drive
guide and the retaining pin with a
lubricant recommended by Geberit.
5
Wipe away excess lubricant using an
absorbent cloth.
54043197424101003 © 12-2023
968.393.00.0(02)
Publicidad
