RAV KTE100 Instrucciones De Uso página 180

Interval
Every 6 years
7.6 Cleaning
Regular and expert care serves to maintain your product's value and serves as a prerequisite for the
preservation of warranty claims.






7.7 Eliminate surface damage
Powder coating
These places are easy to grind (120 grain), clean and degrease. Then finish with a suitable touch-up lac-
quer (observe RAL no.).
Galvanized Surface
The affected areas can be treated by using abrasive fleece with grain size A 280. If necessary, the areas
must be treated with a suitable, resistant material (paint zinc spray, etc.). Observe the RAL colour
scheme.
Rust
The affected areas can be treated by using abrasive fleece with grain size A 280. If necessary, the areas
should be treated with a resistant material (paint, etc.).
7.8 Oil level check
The oil level can be seen on the oil dipstick.
131017
Do not use aggressive and abrasive agents, but gentle cleaners such as comercial
dishwashing liquid and lukewarm water.
Remove dirt with a sponge / brush.
Make sure that no residues of the cleaning agent remain on the lifting table.
No use of high-pressure cleaners (steam jets).
Wipe the lifting table dry with a cloth to prevent corrosion.
If present, re-grease sliding surfaces with multi-purpose grease after cleaning.
Inspection, testing and maintenance
Maintenance activities
Change of hydraulic hoses (→7.11)
Oil change (→7.9)
KTE100
184