EINHELL GE-WS 18/150 Li Manual De Instrucciones página 14

Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
Danger!
This electric power tool generates an
electromagnetic fi eld during operation. Under
certain circumstances this fi eld may actively or
passively impede medical implants.
To reduce the risk of serious or fatal injuries, we
recommend persons with medical implants to
consult their doctor and the manufacturer of the
medical implant prior to using the equipment.
Anl_GE_WS_18_150_Li_USA_SPK7.indb 14 Anl_GE_WS_18_150_Li_USA_SPK7.indb 14
EN
5. Before starting the equipment
Warning!
Switch the equipment off and remove the battery
before carrying out any assembly work.
5.1 Assembling the spray tube and hose (fi g.
3)
Screw the spray tube onto the spray gun handle.
Important! Always check the hose connections.
Any leaks must be remedied immediately and the
equipment must not be used until this has been
done.
5.2 Fitting the harness (Fig. 4 - 5)
Attach the fastening hooks for the harness (20) to
the container on the left and right sides (also see
Fig. 9).
5.3 Preparing spray solution and fi lling the
container (Fig. 6-7)
Switch off the equipment and remove the battery.
Note:
•
Always follow the manufacturer's instructions
when mixing spray solutions. Fill the tank only
with the amount of solution you intend to use.
•
Observe the quantities to be used as listed by
the manufacturer of the solution.
•
Spray solution must have a water-like
consistency.
•
The spray container can be filled with a
maximum 4 Gallons of liquid.
•
Pesticides must only be prepared outdoors
and never in living quarters, stables, or
storage rooms for food and animal feed.
•
Spray solutions can be prepared in a
separate container and mixed thoroughly
before being filled into the container of the
chemical sprayer.
•
If you intend to use organic spray solutions,
they must be filtered prior to filling the sprayer.
•
The solution must always be filled in through
the filling strainer situated in the tank (10).
•
Clean the equipment immediately after each
use. This is the only way to keep the liquid-
carrying parts clean and prevent clogging.
Clogged components can lead to defects.
1. Place the chemical sprayer on a level surface.
Unscrew the tank lid (8) from the tank. On the
inside of the tank lid you will see measuring
ranges with 5ml, 10ml and 25ml contents.
- 14 -
25.07.2023 14:54:35 25.07.2023 14:54:35