EINHELL GE-WS 18/150 Li Manual De Instrucciones página 16

6.3.2 Adjusting the spray jet (Fig. 13)
The spray jet can be adjusted on the nozzle from
a single jet to a wide spray (fi ne mist) for larger
areas.
1. Pause the spraying process.
2. Turn the adjustable spray head
counterclockwise to make the jet narrower
until it is a single jet (1).
3. Turn the adjustable spray head clockwise to
make the jet wider (1).
6.4 Transport
Clip the spray tube to the side of the tank (Fig.
14) or to the tank lid (Fig. 1). Take care that the
spray head does not touch the ground. Transport
the equipment by the tank lid or by means of the
harness.
6.5 After use
Never leave spray solution in the tank. Follow the
instructions in section 7.
•
Check the tank for damage each time before
and after using the equipment.
•
Check the hose and all screw connections for
damage and leaks each time before and after
using the equipment.
6.6 Charging the Lithium-Ion battery (not
included)
The corresponding instructions can be found
in the original operating instructions for your
charger.
6.7 Battery capacity indicator (Fig. 21 / item
23)
Press the battery capacity indicator switch (24).
The battery capacity indicator (23) shows the
charge status of the battery using 3 LEDs.
All 3 LEDs lit:
The battery is fully charged.
2 or 1 LED(s) lit:
The battery has an adequate remaining charge.
1 LED fl ashing:
The battery is empty, recharge the battery.
Anl_GE_WS_18_150_Li_USA_SPK7.indb 16 Anl_GE_WS_18_150_Li_USA_SPK7.indb 16
EN
All LEDs fl ashing:
The temperature of the battery is too low. Remove
the battery from the device and leave it at room
temperature for a day. If the error occurs again,
this means that the battery has been completely
depthdischarged and is defective. Remove the
battery from the device. Never use or charge a
defective battery.
7. Cleaning and maintenance
Hazard!
Always pull out the battery pack before starting
any cleaning work. Never use fl ammable solvents
to clean the equipment.
•
Use only original replacement parts.
•
You must arrange for an authorized customer
service center to carry out any maintenance
and repair work that is not listed below.
•
Unless stipulated otherwise, we recommend
that you arrange for the manufacturer to
check the equipment every 2 years.
7.1 Cleaning (outside)
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the
device. The penetration of water into an
electric tool increases the risk of an electric
shock.
7.2 Cleaning the inside of the container (Fig.
6-7)
After use, clean the equipment and leave
the container open to dry. Note the cleaning
instructions in the directions for use that came
with the chemical in addition to these cleaning
instructions.
Remove any remaining liquid from the tank
through the container's fi ller opening and store
- 16 -
25.07.2023 14:54:35 25.07.2023 14:54:35