Health O Meter Professional 349KLX Manual Del Usuario página 14

SET UP INSTRUCTIONS (CONT)
Setting Auto Zero
This option allows the user to select whether the scale will re-set itself to ZERO each time it is
powered up or whether it will use the zero reading from the last time it was zeroed. The auto zero
default setting is "enabled" Follow this procedure to enable or disable this feature.
1. While the scale is turned off, press and hold the ZERO button then press and release the
ON button. Hold the ZERO button until "AF=d" or "AF=E" appears on the display, then
release. Use the ON or OFF buttons to advance the display screen until "P2" appears. Press
the lb./kg button to change the setting.
P2 = d Disabling this feature means the scale does not attempt to find a zero when
powered on, rather it will use the zero setting it had from its most recent use.
Health o meter
users should manually zero the scale before each weight measurement by
pressing ZERO. Users will see dashes on the screen as the scale is finding zero.
P2 = E Enabling this feature means the scale will zero itself when it is powered on. After
each use, the scale will clear the weight of the patient and set itself back to the
initial zero level it found on start-up. Health o meter
keeping this setting as Enable.
2. Choose the setting you prefer and press ZERO to save your selection and exit the Options
mode.
3. The scale will restart. The display will show "UEr", followed by a version number, and then
dashes. When the display shows "0.0" the scale is ready to use.
®
Everlock
(349KLX only, this feature is not available on 349KGX)
®
The Everlock feature allows the measuring unit to be permanently locked on the scale, disabling
the lb./kg button. The Everlock
®
Everlock .
Warning: This lock is permanent and cannot be reversed.
Notes:
• Press ZERO at any time to exit the Everlock
• Once Everlock
®
is engaged the UL and UD options will no longer be displayed when scrolling
through the Options menu.
• There is no method to undo Everlock
1. While the scale is turned off, press and hold the ZERO button then press and release the
ON button. Hold the ZERO button until "AF=d" or "AF=E" appears on the display, then
release. Use the ON or OFF buttons to advance the display screen until "EL" appears. Press
the lb./kg button to change the setting.
EL =d Default setting with Everlock
EL = E Engages Everlock
begin the locking procedure. If this is desired, follow the instructions below.
is selected, "PASS1" will appear on the display. This prompts the user to
®
1. After Everlock
enter a password. Press the following keys in this sequence:
lb./kg, OFF, ON
2. If entered correctly, "EL=L" (if scale was in LB mode) or "EL=6" (if scale was in KG mode)
will appear on the display.
3. Press lb./kg to toggle between (L) Pounds and (6) Kilograms. When the desired unit is
displayed, press the ON button and "PASS2" will appear on the display.
4. This will prompt the user to enter the second password. Press the following keys in this
sequence:
OFF, lb./kg, ON
6. If entered correctly, the scale will display "EL = L" or "EL = 6," depending on the unit of
measurement that was selected. Everlock
UM349KLX REV20230913
®
Professional recommends that if the Disable option is selected,
default setting is "disabled". Follow this procedure to engage
®
®
procedure.
®
without sending the scale back to the manufacturer.
®
disabled.
®
. Once this option is selected, the display will prompt you to
®
is now engaged.
14
Back to Home Page
®
Professional recommends