LORCH Handy 200 BasicPlus Manual De Instrucciones página 36

14 Starting up
Make sure before turning-on, that
the electrode holder, electrode do
not touch on the welding table, the
working piece or any other object
which is conductive. Oth-erwise
an arc will be ignited accidentally.
An accidentally ignited arc can
damage the electrode holder, the
welding table, the working piece or
the machine.
14 .1 Electrode welding process
Switch on machine
 Turn on the machine at mains switch 2.
 Press key button 18 until the selected
electrode mode appears.
9 Symbol for electode basic, rutile or CEL
(LED 15, 16 or 17) will light up.
 Set the required welding current with tur-
ning knob 13.
Ignition
 Touch the workpiece with the tip of the
electrode and lift the electrode a bit.
9 The arc ignites between the workpiece
and electrode.
Hotstart (Handy 200 BasicPlus)
‰ During the electrode welding process, ig-
nition will take for 1 second a hotstart with
125% of the set welding current. The hot-
start is, like the welding current, limited to
max 200A.
- 36 -
14 .2 TIG welding process
Switch on machine
 Turn on the machine at mains switch 2.
 Press key 18 for 2 seconds.
9 TIG Symbol (LED 14) will light up.
 Set the required welding current with tur-
ning knob 13.
Ignition
 Open the valve 56 at the TIG torch
 ÂTouch the workpiece with the tip of the
Â
electrode.
 ÂLift the electrode a bit.
Â
9 The arc ignites between the workpiece
and electrode.
Upslope
‰ For the TIG welding process, a short circuit
of 60A is used. The current increase fol-
lows with 115A/s until the adjusted welding
curren is reached.
Reference values for current and gas flow
Diameter of
Tungsten
Electrodes
[mm]
1,0
1,6
2,4
Starting up
Current Gas Flow
[A] [l/min]
15...80 4
70...150 5...6
150...250 6...7
10.15