Assembly And Installation Manual; B1 Pulimatic Installation - Acqua Brevetti FT370 Manual De Instrucciones Para El Uso Y Mantenimiento

ASSEMBLY AND INSTALLATION MANUAL

B1 PULIMATIC INSTALLATION

B1.1 Before the installation
WARNING! Before the installation of PuliMATIC please verify that the water supplied fulfills the
requirements of European drinking water directives
hydraulic distribution system and the installation of the filter to local regulations. The manufacturer
disclaims all responsibility for damage to persons or things caused by improper installation of the filter
and/or the installation of the filter in a waterworks not compliant with local regulations.
PuliMATIC is not equipped, by standard, with any flooding-control system or other devices able to detect,
control or alarm in case of runaway water losses. In case, consider, apart, an adequate anti flooding device.
Do not install the filters downstream of boilers or in devices involving the transit, inside the filter, of water
at higher than 30°C temperature. Install the filters upstream of devices to protect. PuliMATIC cannot be
used to treat closed loop water (ex. heating systems water) or any other applications not cited in this
manual.
B1.2 Requirements for the place of installation
PuliMATIC must be installed in an in an hygienically suitable place, dry and clean, protected from frost,
exposure to sunlight, moisture, atmospheric agent (rain, snow and hail). Do not install PuliMATIC in wells,
near drains, or in smelly places. Do not install where any kind of chemical vapours or gas and fumes may be
present. Avoid installation in tight spaces which cannot allow easy ordinary and extraordinary maintenance.
In succession the limit values of the allowed environmental parameters for the filters installation:
Ambient temperature (min./max.), °C:
B1.3 Laws, Regulations and Standards
The installation of the filters must be performed in compliance with local laws, regulations and standards.
B1.4 Instruction for installation
The installation must be performed in accordance with best practice, in line with all the current legislation
and the rating data.
Before installing the filter make sure that the plant fits with the laws or regulations or local
recommendations produced by the office in charge. Before installing the filter, clean pipes and appliances
installed upstream of the filter in order to eliminate foreign bodies which can cause the malfunction of the
filter itself. If the level of cleanliness in the plant is not adequate you should sanitize the plant and the
possible storage tanks before the installation of the filters. The filter should not be installed between the
boiler and safety devices.
The hydraulic distribution system implemented to install devices connected to the water distribution
system must be provided with a system able to ensure the no return of the treated water in the
distribution system, and with a manual or automatic by-pass valve system in order to allow the withdrawal
of no treated water interrupting the flow of treated water.
Warning! Avoid solvents, oils, acidic or caustic substances and detergents to come in contact with the
external plastic and brass part of the device. In case of very strong impact during the transport or the
assembly do not install the device and replace it even in case of no apparent damages to the plastic
parts. Limit the presence of water hammer.
MAN141 – Rev.1
PULIMATIC - ENGLISH
98/83/CE.
5 – 40
Check for the compliance of the
PAG. E-14