Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
UNPACKING & SETUP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach accessories following the instructions
in this manual.
3. Before replacing power head, refer to this
manual to ensure you have the proper filter
installed for the cleaning operation.
4. Replace power head, and apply pressure
with thumb to each latch until it snaps
tightly in place. Make sure all lid latches are
clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) to
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The vacuum
is ready for use.
9. To reduce the risk of injury from accidental
starting, always shut off vacuum and
disconnect the power plug from the wall
outlet before installing any part or
cleaning accessory.
WARNING: Do not alter the plug in any
way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet.
WARNING: To reduce the risk of fire or
explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the
air. Flammable gases or vapors include but are
not limited to: lighter fluid, solvent-type cleaners,
oil-based paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to:
coal, magnesium, aluminum, and grain or gun
powder. Do not vacuum explosive dust,
flammable or combustible liquids or hot ashes.
Do not use this vac as a sprayer for any
flammable or combustible liquid. To reduce the
risk of health hazards from vapors or dusts, do
not vacuum toxic materials.
WARNING:
The operation of any utility
vac can result in foreign objects being blown
into the eyes, which can result in severe eye
injury. Always wear safety goggles complying
with ANSI Z87.1 (or in Canada, CSA Z94.3)
before starting operation.
UNPACKING & SET-UP SUMMARY
1. Pull lid latches in an outward motion, remove
power head and some accessories that may
have been shipped in the tank.
2. Attach casters following the instructions below:
a. Use provided casters and insert into the bottom
of caster base. Strong pressure required and
listen for the click to ensure locked in place.
b. Return dust tank assembly upright.
3. Before replacing power head, refer to this
manual to ensure you have the proper filters
installed for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5. Insert the hose end into inlet of tank.
6. Attach the extension wands to the end of the
hose. Apply slight pressure until fitting is tight.
7. Attach one of the cleaning accessories
(depending on the cleaning requirements) on
the extension wands. Twist slightly to tighten
the connection.
8. Plug the cord into the wall outlet. The cleaner is
ready for use.
9. Turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the
"OFF" position and the "I" is the "ON" position.
O = OFF I = ON
4
Publicidad
