Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: To reduce the risk of fire or
explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the
air. Flammable gases or vapors include but are
not limited to: lighter fluid, solvent-type cleaners,
oil-based paints, gasoline, alcohol or aerosol
sprays. Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum explosive
dust, flammable or combustible liquids or hot
ashes. Do not use this vac as a sprayer for any
flammable or combustible liquid. To reduce the
risk of health hazards from vapors or dusts,
do not vacuum toxic materials.
WARNING: The operation of any utility
vac can result in foreign objects being blown
into the eyes, which can result in severe eye
injury. Always wear safety goggles complying
with ANSI Z87.1(or in Canada, CSA Z94.3)
before starting operation.
CAUTION: To reduce risk of hearing
damage, wear ear protectors when using the
vacuum for extended hours or when using it in
a noisy area.
INSTALLING THE DISPOSABLE FILTER BAG
1. Slide the cardboard collar opening firmly onto
the vacuum port deflector until it stops against
the deflector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
3. Replace and secure the power head onto the
tank.
Disposable
filter bag
DRY PICK-UP
1. The filter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the filter is completely
covering the filter cage. Make sure there are
no gaps between the filter and the lid
(See illustration). It is very important to
assemble the filter to the cage without any
possible leaks or tears. Any leaks will allow
the picked up debris to be blown out of the
blowing port and back into the surrounding
environment.
2. When using the vac to pick up fine dust,
it will be necessary to empty the dust tank
and clean or replace the filter at more
frequent intervals to maintain peak vac
performance.
3. The foam filter and reusable dry filter with
ring must be installed for dry pick up.
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is
wet, the filter will clog quickly and be very difficult
to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
WET PICK-UP
1. Remove reusable filter and replace it with foam
filter when you do wet pickups.
2. This wet/dry vac is equipped with a float
mechanism which will rise automatically to
cut off the airflow when the liquid in the tank
reaches a predetermined level. When this
happens, turn off vac, unplug the power cord,
and empty the dust tank. You will know that
the float has shut the airflow off because the
suction ceases and the motor noise becomes
higher in pitch due to increased motor speed.
The liquid capacity may vary with the rate of
pickup.
IMPORTANT: To reduce the risk of damage to
the vac, do not run motor with float in raised
position.
Foam filter
Float in raised
position
NOTICE:
IF ACCIDENTALLY TIPPED OVER, THE VACUUM
COULD CLOSED SUCTION. IF THIS OCCURS,
PLACE VAC IN UPRIGHT POSITION AND TURN
SWITCH OFF. THIS WILL ALLOW THE FLOAT TO
RETURN TO ITS NORMAL POSITION, AND YOU
WILL BE ABLE TO CONTINUE OPERATION.
5
ENGLISH
Reusable filter
Clamp ring
Publicidad
