ECOVACS WINBOT W2 OMNI Manual De Instrucciones página 11

5. Wet and wring out the Wiping Pad and place it flat on the velcro at
the bottom of WINBOT. Pay attention to align the narrow and wide
side accordingly.
6. Make sure to place Station on a flat, seamless surface.
EN 10
7. Long press START button for 2 seconds to start the fan. Place
the bottom side of WINBOT (the side with Wiping Pad) against the
window; WINBOT will auto-attach itself and start cleaning.
2
*Before cleaning, please observe the area to attach WINBOT for any small particles. If there
are any, please remove them or switch to a particle-free area to avoid scratching the glass.
*Clean the Wiping Pad in time and make sure that any small particles on it are completely
removed to avoid scratching the glass.
8. When cleaning is completed, WINBOT automatically returns to
the Initial Spot and waits to be removed. At this point, long press
START button for 2 seconds to stop the fan. Then, take WINBOT off
according to voice prompts.
2
*If the vacuum glass, which WINBOT is working on, is leaking, remove WINBOT immediately
after cleaning is completed.