Ryobi ID-700RE Manual De Utilización página 9

GB
F D E
INSTRUCTIONS FOR SAFE HANDLING
Check damaged parts. Before further use of the tool,
a guard or other part that is damaged should be
carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment breakage of parts, mounting and any other
conditions that may affect its operation. A guard or other
parts that is damaged should be properly repaired
or replaced by an authorized service centre unless
otherwise indicated in this instruction manual.
Have defective switches replaced by an authorized
service facility. Do not use the tool if the switch does
not turn it on and off.
Make sure that the drill bit is securely mounted.
An incorrectly mounted bit is extremely dangerous
since it can fly off or break during drilling.
Dress properly. Do not wear loose clothing or jewellery,
they can be caught in moving parts. Rubber gloves
and non-skid footwear are recommended when
working outdoors. Wear protecting hair covering
to contain long hair.
Hold the tool securely with both hands. If not held
securely, accidents or injury may result.
Never touch the chuck or metal body parts when
drilling walls, floors, or other surfaces covering
electrical wiring. Hold the tool only by the plastic
handle to prevent electric shocks.
While operating, the work piece must be securely
held with the vise or the clamp etc. to prevent it from
moving it due to the drill rotation.
SPECIFICATIONS
ID-700RE
Voltage 230V ~ 50Hz
Chuck capacity 13 mm (1/2")
Drilling capacity
in wood 30 mm
in steel 13 mm
in masonny 13 mm
Input 700 W
No load speed
high 0 - 3,000 min
low
Blows per minute
high 0 - 48,000 min
low
Net weight 2.2 kg
Safety class II
I P NL S DK
English
STANDARD ACCESSORIES
Auxiliary handle, Depth Stopper, Drill Bit, Screw Bit &
Wall anchor.
APPLICATIONS
(Use only for the purposes listed below.)
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can
exceed 85 dB (A). in this case, sound insulation and hearing
protection measures must be taken by the operator.
SWITCH (FIG. 1 & 3)
CHANGING THE ROTATION DIRECTION (FIG. 2)
ID-750-2RE
230V ~ 50Hz
13 mm (1/2")
30 mm
13 mm
13 mm
750 W
-1 0 - 3,000 min -1
MOUNTING AND REMOVING THE BIT (FIG. 4 )
0 - 1,000 min -1
-1 0 - 48,000 min -1
0 - 16,000 min -1
2.6 kg
6
N FIN GR H CZ
Drilling wood, materials and resin boards.
Drilling concrete (impact drilling only).
Drill metal steel brass, aluminum sheets, stainless
steel & pipe.
This tool is started and stopped by squeezing
and releasing the trigger switch (A).
The speed can be adjusted in the high gear or in
the low gear, by controlling the frigger-squeezing force.
For continuous operation, press the lock button (E)
while squeezing the frigger. Squeeze again to release
the lock.
To change the rotation direction, stop the tool and
push the forward / reverse button (B).
When the forward button is pushed in, the bit rotates
clockwise when viewed from the handle end of the tool.
When the reverse button is pushed in, the bit rotates
counterclockwise.
Insert the bit (J) into the chuck (C) as far as it will go.
Then tighten the chuck securely by rotate the chuck
head to left hand side.
The bit can be removed by rotate the chuck to right
hand side.
RUS RO PL