Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Cleaning, maintenance and storage
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
After use and before storage
Regularly clean the ventilation slots with a clean, dry paint
brush.
To clean the tool, use only mild soap and a damp cloth. Never
let any liquid get inside the tool and never immerse any part of
the tool into liquid.
Remove debris using a hard brush.
u
Lubricate the chain (8) with oil.
u
Saw chain sharpening
If you are to get the best possible performance from the tool it
is important to keep the teeth of the saw chain sharp.
Guidance for this procedure is found on the sharpener
package. For this purpose we recommend the purchase of the
BLACK+DECKER saw chain sharpening kit, available from
your BLACK+DECKER service agents (cat. no. A6039).
Replacing worn out or damaged saw chains and guide
bars
Replacement saw chains are available through retailers and
BLACK+DECKER service agents (pt no A6158), replacement
guide bars are only available through BLACK+DECKER
service agents (pt no 90517720).
To avoid the risk of injury, use only original BLACK+DECKER
chains and guide bars. Always use genuine spare parts.
Saw chain sharpness
The saw chain cutters will blunt immediately if they touch the
ground or a nail whilst cutting.
Saw chain tension
Regularly check the saw chain tension.
What to do if your chainsaw needs repair.
Your tool is in accordance with the relevant safety
requirements. Repairs should only be carried out by a
qualified person using original spare parts otherwise this may
result in considerable danger to the user. We recommend you
keep this user manual in a safe place.
12
(Original instructions)
Storage
When the tool will not be used for several months, ideally
leave the battery (10) connected to the charger.
Otherwise proceed as follows:
Remove the battery (10) from the tool.
u
Fully charge the battery (10).
u
Store the tool and battery (10) in a secure and dry
u
location. The storage temperature must always remain in
the range of +10°C to +40°C. Place the battery (10) on a
level surface.
Before using the tool after prolonged storage, fully charge
u
the battery (10) again
Z
Protecting the environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
Voltage
Chain speed (No-load)
Weight
Battery
Voltage
Capacity
Type
Charger
Input Voltage
Output Voltage
Output Current
Guaranteed sound pressure level measured according to EN62841:
LpA (emission sound pressure level ) 78 dB(A), uncertainty (K) 3 dB(A)
LwA (measured sound power level ) 94 dB(A), uncertainty (K) 1.9 dB(A)
Vibration total values (triax vector sum) according to EN 62841:
Vibration emission value (a
GKC1820L 20 Type 3
V
DC
m/min
kg
V
DC
Ah
905902**TYPE 1
V
AC
V
DC
mA
)= 5.5 m/s², uncertainty (K) = 1.5 m/s²
h
18
190
1.55
BL2018
18
2.0
Li-Ion
100–240
8–20
400
Publicidad
