4. INSTALLATION
4.1. PLACEMENT
10cm
10cm
10cm
W
Front view
10cm
B
135°
A
Top view
•
This refrigerator needs to be installed independently and cannot be used as a
built-in. Otherwise, it will cause problems such as failure to install into the cabinet,
•
Before use, remove all packing materials, including
bottom cushions, foam pads and tapes inside the
refrigerator; tear off the protective film on the doors
and the refrigerator body.
•
Please leave the packaging materials and other
parts out of reach of children to prevent from risk of
suffocation.
•
Keep away from heat and avoid direct sunlight. Do not
place the freezer in moist or watery places to prevent
rust or reduction of insulating effect.
•
Do not spray or wash the refrigerator; do not put
the refrigerator in moist places easy to be splashed
with water so as not to affect the electrical insulation
properties of the refrigerator.
•
The refrigerator is placed in a well-ventilated indoor
place; the ground shall be flat, and sturdy (rotate left or
right to adjust the wheel for levelling if unstable).
10cm
10cm
H
(without handle)
D
Side view
(Unit: mm)
The measurements in the above table
may differ, depending on the measuring
method.
11
Width "W"
595
Depth "D"
618
Height "H"
1850
A
1017
B
1025
EN