Publicidad
Idiomas disponibles
Idiomas disponibles
Install Range Hood
I WARNING
EXCESSIVE WEIGHT HAZARD.
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
RANGE HOOD.FAILURE TO DO SO CAN RESULT IN BACK OR
OTHER INJURY.
1
Remove the polyurethane piece that comes inside the hood.
2
Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19
mm screws into the hood canopy assembly and tighten all
(8) mounting screws.
A
3
Remove the protective from the metal grease filters and
pull them out from the face panel.
4
Pull out the lamps connector cables
5
Attach the mounting brackets to the inside of the hood
as shown in the picture, using four 3.5 x 6.5 mm screws.
B
A. Mounting brackets (2)
B. Screws - 3.5 x 6.5 mm (4)
6
Attach the lower panel to the hood insert, with the
plate open, place four screws 3.5 x 6.5 mm securing the
panel to the previously placed brackets as shown in the
diagram.
10
A. Cabinet
B. Hood liner canopy
assembly
C. Screws - 4.2 x 19
mm (8)
B
C
A
NOTE: If cabinet depth is greater than 12", it is
recommended that the two
installed. Install to front and rear sides of the face plate with
round head 3.5 x 9.5 mm screws as shown in drawing.
B. Screws - 3.5 x 6.5 mm (4)
7
Install the two 4.2x15 mm screws located on the sides of
the hood controls.
A. Screws - 4.2 x 15 mm (2)
1
⁄
" metal spacers are
2
A. Face plate
A. Front and rear
spacer
B. Screws - 3.5 x 9.5
mm (4)
Publicidad
