Publicidad
Idiomas disponibles
Idiomas disponibles
Non-vented (recirculating installation through the soffit/
A
G
B
D
F
E
H
cabinet
A. Ceiling
F. Cabinet
B. Vent cover
G. Wall
C. Soffit
H. 12" (30.5 cm) min. cabinet height
D. 6" (15.2 cm) vent
I. 17" (43.2 cm) min. vent cover height
E. Range hood
1
Measure and mark the centerline of the cabinet to the
soffit above.
2
Measure from the bottom of the cabinet to the centerline
of the where the vent will come through the soffit. Mark
the location and use a saber saw or keyhole saw to cut a
5¾" (14.6 cm) hole for the vent cover.
A
B
*NOTE: For 12" (30.5 cm) height cabinets a 6¼" deep x 8" wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3
Consider the cutout chart measures to make the openings
on the cabinet.
Complete preparation
1
If not yet attached, install the 6" (15.2 cm) vent transition
the top of the range hood liner using two 3.5 x 9.5 mm screws.
2
Locate side mounting bracket 1 cm bottom to top side
and against the inside of the front cabinet face. Orient the
bracket depending on the width of your cabinet as depict-
ed in the diagrams below. Drill
places, attach a bracket using four 4.5 x 13 mm screws to
each side of the cabinet, and tighten. Additional washers
in hardware package are supplied as spacers for cabinet
walls thinner than ½"(13 mm).
Bracket Orientation for 30" (76.2 cm) Cabinet
B
A
A
B
G
C
F
D
I
E
A. Vent cover
B. Centerline
⁄
" (3 mm) pilot holes in 6
1
8
C
D
A. 30" (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C. Washers (optional)
D. Mounting bracket (2) (position for 30" [76.2 cm] cabinet)
Bracket Orientation for 34.5" (87.68 cm) Cabinet
C
A
B
D
A. 34.5" (87.68 cm) cabinet
B. Screws - 4.5 x 13 mm (8)
C. Washers (optional)
D. Mounting bracket (2) (position for 34.5" [87.68 cm cabinet)
Bracket position
with 1 spacer
6.35cm
3
Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
Move the bracket
⁄
" (1 cm)
6
1 6
from the bottom side of the
cabinet
Bracket position without spacers
6.4cm
6.35cm
Bracket position
with 2 spacers
7.7cm
7.6cm
9
Publicidad
