Pando integralCooking 10258 Manual De Uso E Instalación página 130

INOXPAN S.L. BEVERAGE COOLER
6. CARE AND MAINTENANCE
WARNING: If you do not disconnect the unit before maintenance or cleaning, there is the risk of
an electric shock or harm.
6.1. CLEANING THE UNIT
Disconnect the power, unplug the appliance and remove everything inside, including the shelves.
Wash the interior surfaces with warm water and sodium bicarbonate (Baking soda) The solution
should be approximately 2 spoons of sodium bicarbonate to a liter of water.
Wash the shelves with a mild detergent solution.
Dry any excess water with a sponge and a cloth to clean the control area Displays / front buttons.
Wash the exterior with hot water and mild liquid detergent. Rinse well and dry with a soft clean
cloth.
Do not clean stainless steel parts with metal scouring pads or abrasive sponges. It is
recommended to use an all-in-one stainless-steel cleaner and always wiping in the direction of the
grain.
The sealing gasket around the door must be cleaned regularly to prevent discoloration and
prolong service life. Use clean water. After cleaning the sealing gasket, check that it continues
to provide a tight seal.
6.2. POWER CUTS
In case of a power cut, all the temperature settings will be memorized automatically. If there is a
power cut (Voltage surge, circuit breaker, etc.) and it is later switched on, the unit will restart at
the last temperature setting.
Most power cuts last a few hours and should not affect the temperature of the unit if you minimize
the number of times the door is opened. If power is going to be cut for a longer period, it will be
necessary to take measures to protect the contents.
NOTE: Regardless of the cause, if you notice an abnormal temperature or variations in the level
of humidity inside the unit, only long and frequent exposure to these abnormal conditions can have
adverse effect on your beverage.
6.3. DURING HOLIDAYS/ LONG ABSENCE
Short holidays: Leave the unit working during holidays lasting less than three weeks.
Long absence: If you are not going to use the unit for several months, empty it, switch it off and
unplug it. Clean the inside and dry well. To avoid mold growing and bad smells, leave the door
ajar, blocking it is necessary.
130