Publicidad
Idiomas disponibles
Idiomas disponibles
4. Change rotation speed
Shift knob
Operate the shift knob to change the rotational speed. Move the shift knob in the direction
of the arrow (see Figs. 7 and 8).
When the shift knob is set to "LOW", the drill rotates at a low speed. When set to "HIGH",
the drill rotates at a high speed.
CAUTION:
G When changing the rotational speed with the shift knob, confirm that the switch is off.
Changing the speed while the motor is rotating will damage the gears.
G When a large force is required for operation (operations indicated in the following chart)
set the shift knob to "LOW". If "HIGH" is set and the unit is used, it may cause the motor
to burn out or malfunction prematurely.
Model
Metal Drilling
Wood Drilling
Wood Screw
Tightening
5. Confirm the cap position (see Fig. 9)
Cap
Triangle mark
Fig. 9
Drill mark
Triangle mark
White
line
Fig. 10
High speed
Fig. 7
DS14DVB
When the diameter of the hole
exceeds 1/4"(6.5mm).
When the diameter of the hole
exceeds 11/16"(18mm).
When the size of the wood screw exceeds 3/16"(4.8mm) diam-
eter × 1-9/16"(40mm).
The tightening torque of this unit can be adjusted accord-
ing to the cap position, at which the cap is set.
(1) When using this unit as a screwdriver, line up the one of
the numbers "1, 3, 5 ... 22" on the cap, or the white dot,
with the triangle mark on the outer body.
(2) When using this unit as a drill, line up the cap drill mark
" " with the triangle mark on the outer body.
CAUTION:
The cap cannot be set between the numerals "1, 3, 5 ... 22"
or the white dot.
Do not use with the cap numeral at "22" and the white
line at the middle of the drill mark. Doing so may cause
damage. (See Fig. 10)
Shift knob
Low speed
Fig. 8
DS18DVB
When the diameter of the hole
exceeds 5/16"(8mm).
When the diameter of the hole
exceeds 15/16"(24mm).
English
17
Publicidad
