Dreame X40 Ultra Manual Del Usuario página 11

How to Use
EN
3. Automatically empty the dust box and wash and dry the mop
pads
After the robot finishes a cleaning task and returns to the base station to
charge, the base station will automatically start emptying the dust box. Then
it will wash and dry the mop pads.
Note:
· If the auto-empty function is turned off in the app, the base station will not
automatically empty the dust box.
· The base station will empty the dust box according to the setting in the app.
4. Clean the used water tank
After the robot has completed its task, please clean the used water tank to
prevent any odor.
16
Mop after Vacuuming
Enable the mopping after vacuuming function in the app, and the robot will
automatically remove the mop assembly on the base station to vacuum the
floor. After vacuuming is completed, the robot will return to the base station
to install the mop assembly and the base station will automatically start
emptying the dust box. And then, the robot will start mopping after the main
brush and side brush are raised.
Vacuum Only
Enable the vacuuming function in the app, and the robot will automatically
remove the mop assembly on the base station and start vacuuming.
Mop Only
Enable the mopping function in the app, and the robot will automatically check
if the mop assembly is installed on the base station. If not, the robot will install
the mop assembly and start mopping after the main brush and side brush are
raised.
Routine Maintenance
Parts
To keep the robot in good condition, it is recommended to refer to the accessory usage in the app or the following table for routine maintenance.
Part Maintenance Frequency Replacement Period
Used water tank After each use
/
Clean water tank
Main brush Every 6 to 12 months
Once every 2 weeks
Dust box's filter
Every 3 to 6 months
Side brush
Mop pad holder /
Washboard Once every 2 months /
Base station's
signaling area
Base station's
charging contacts
Base station's
auto-empty vent
Omnidirectional Once every month /
wheel
Edge sensor
Laser Distance
Sensor (LDS)
3D dual-line laser
sensors
Part Maintenance Frequency Replacement Period
Carpet sensor
Cliff sensors
Bumper Window
Robot's charging
contacts
Once every month
Bumper
/
Robot's auto-empty
vent
Robot's automatic
water refilling inlet
Bottom of the robot
Dust box Clean it as needed
Dust bag Every 2 to 4 months
/
Mop pad Every 1 to 3 months
Note: The replacement frequency will depend on your usage of the robot.
If an exception occurs due to special circumstances, the parts should be
replaced.
EN
17